|Some industries Generates the waste in Powder
form. Or sometimes, the waste need to be crushed and required
to convert it in Powder form. Some waste cakes have good
calorific value, but it takes much time for burning, in that
case, it's better to prepare powder of such waste and spray it
inside the chamber for incineration. By this technology, the
incineration will be done faster and with lower fuel
We design the Powder waste incinerators with special powder
spraying system which use hot air to spray powder. The hot air
is created by the jacket provided on the chamber, so No extra
fuel required for such hot air. The Powder spraying system,
spray the powder in Primary Chamber and then the fume passes
through secondary chamber, then scrubbing system and Chimney.
We Design the incinerators as per specific waste. Before that, we ask
you to provide as much
information as possible about the waste. We calculate the flue
gases volume and impurities generation while disposal of the waste.
We have inhouse testing laboratiry for testing of the waste.
We design the incinerators with Emission Standards, Norms
& Guidelines for manufacturing the incinerators. Though
Primary & Secondary Chamber's working temperatures are
850° C & 1100° C, We make them to Withstand Higher
Temperature up to 1200° C & 1400° C for Longer
Life of the incinerator System. If possible, we also
provide option for Heat Recovery. We also care for Lower
Fuel Consumption while incineration.